|
Rymar Premium Wood Sealer
Application Suggestions for Decks
- Let new wood dry for 30 days.
After project completions, allow wood to dry (cure) for 30 days before starting the sealing procedure.
- Clean
To clean, first wet wood. Then use Rymar Rinseable soap and follow the directions on the box. Rinse, let dry, then seal.
- Sealing Your Project
Apply sealer until it no longer penetrates. Brush out any puddles of sealer that develop. Let dry for at least 48 hours before using, longer drying time may be required in cooler, damper weather. Sealer may be applied with a brush, sprayer, or by dipping. Premium requires step 4.
Xtreme is a wet on wet application. Seal 3-4 boards, seal them again while wet or tacky; this equils 2 coats and won't require step 4.
- Resealing with Premium Sealer
After 90 days clean surface with Rymar Rinseable soap and water, rinse and let dry. Apply sealer, again being careful not to allow puddles of sealer to develop. Allow to dry before using deck.
Do Not apply sealer when these conditions exist ...
-
Do Not apply sealer if you have not read the warnings and instructions on label of container.
-
Do Not apply sealer if the wood is wet.
-
Do Not apply sealer if the wood is dirty.
-
Do Not apply sealer if the air temperature is below 45 degrees or above 90 degrees.
-
Do Not apply sealer if the surface temperature of the wood is above 90 degrees.
Do apply sealer ...
-
Apply sealer after it has been stirred well and also stir frequently during application.
-
Apply sealer the entire length of 2 or 3 boards at a time for uniform color appearance.
-
Apply sealer with a brush, sprayer or by dipping.
-
Apply sealer only after checking the color of each can by brushing a small test area.
-
Clean equipment with mineral spirits and dispose of rags properly.
|
